Cleaning Pods Guide for Keurig®

Full Version: Full and Extended Instructions

Ensure water reservoir is full; place large container under brew spout.

1. Insert pod, close handle, and press small cup or Cocoa/other brew button.
2. Wait 1 minute.
3. Remove used pod (CAUTION: Hot!). Don’t drink solution!
4. Rinse with large brew button.
5. Open and close brewer. Press large brew button to rinse again.
6. Discard solution or use to soak drip tray for 10 minutes, then rinse.

AFTER CLEANING: Clean the appliance. Wipe inside of pod holder. CAUTION! Brew needle

Download cleaning instruction leaflet here

Full and Extended Instructions

Power on brewer; place large mug under brew spout.

1. Fill the water reservoir with 6 fl oz/177 ml of water.** 
2. Insert the cleaning pod into the pod holder. 
3. Lower the handle and press the 6 fl oz brew button, waiting for the cycle to finish. 
4. Remove the used pod (CAUTION: Hot!). Don’t drink solution! 
5. For rinsing, fill the water reservoir to max (10 fl oz/295 ml). 
6. Ensure pod holder is empty, lower the handle, and press the 10 fl oz brew button to rinse, waiting for the cycle to finish. 
7. Repeat the rinse (steps 5-6). 
8. Discard solution or use to soak drip tray for 10 minutes, then rinse. 

**Some Mini brewers may require you to lift and lower handle first to fill water compartment.

Full and Extended Instructions

Power on brewer; place large mug under brew spout.

1. Fill the water reservoir with 8 fl oz/237 ml of water.** 
2. Insert the cleaning pod into the pod holder. 
3. Press the POD button.
4. The different cup size buttons will blink, press the 8 button. 
5. The brew light will blink, press the brew button to start the cleaning cycle.
6. NOTE*: The cycle will only begin once the brewer is heated, after +- 4 minutes, when the brew light turns solid.
7. Once complete, remove the used pod (CAUTION: Hot!). Don’t drink solution! 
8. For rinsing, fill the water reservoir to max. 
9. Ensure pod holder is empty, lower the handle, and repeat steps 3-5 (press 10 instead of 8) to rinse, waiting for the cycle to finish. 
10. Repeat the rinse by lifting and lowering handle, then repeat steps 3-5 (press 10 instead of 8). 
11. Discard solution or use to soak drip tray for 10 minutes, then rinse. 

Full and Extended Instructions

Power on brewer; place large mug under brew spout.

1. Fill the water reservoir to the MAX line with water.** 
2. Insert the cleaning pod into the pod holder. 
3. The 3 cup sizes button will blink, then press the 8 button. 
4. The brew button will start blinking, press it to start the cleaning cycle.
5. Once complete, remove the used pod (CAUTION: Hot!). Don’t drink solution! 
6. For rinsing, fill the water reservoir to max again. 
7. Make sure the pod holder is empty, lower the handle, and repeat steps 3-5 (press 10 instead of 8) to rinse, allow the cycle to finish. 
8. Repeat the rinse by lifting and lowering handle, then repeat steps 3-5 (press 10 instead of 8 again). 
9. Discard solution or use to soak drip tray for 10 minutes, then rinse.